Car Diagnostic Scanner Mitsubishi MUT-3

A personal computer (PC) is connected to the MUT-3 unit and used as a system's control terminal, and communicates with a vehicle ECU through the VCI. In addition to being able to handle all diagnosis functions covered by the conventional MUT-II tester, the MUT-III system can display data as easy-to-understand diagrams and graphs on a large screen of the PC. Unlike the MUT-II, the MUT-III can retain data on all vehicles, from old to new models, classified according to destination in the PC's hard disk. This eliminates the awkward but essential job with the MUT-II, of switching the data list (communications protocol data and diagnosis item list database) by replacing the ROM pack with another according to the vehicle model and year model.
(1) Vehicle Communication Interface (V.C.I.) (MB991824)
Vehicle Communication Interface (V.C.I.) (MB991824)
A communication interface used to connect the vehicle
ECUs and the PC.
1. When connected with the PC
Vehicle diagnosis (Interactive fault diagnosis)
SWS communication & CAN communication support
Drive recorder
ECU reprogramming
Volt, Ohm, measurement
Fuel pressure measurement (Not available in US)
2. When used with the V.C.I. unit (disconnected from PC)
V.C.I. Stand-alone diagnosis
Drive recorder
ECU reprogramming
Volt, Ohm measurement
Belt Tension measurement
(2) Memory Card
Stores data for ECU reprogramming, drive recorder, etc.
This is a standard, off-the-shelf memory card. The one
provided (with reprogramming data) is a Compact Flash
memory card (MB991853, MB992228) inserted into the CF
card adapter (MB991939).
It is necessary to initialize a Compact Flash memory card
by FAT16 and FAT32 format. (NTFS format cannot use)
(3) M.U.T.-III Main Harness A (MB991910)
Used when connecting the V.C.I. with vehicles that have
only one 16-pin diagnosis connector.
Supports fault diagnosis and ECU updating on the
above-described vehicles
Supports the CAN communication system
(4) MUT-3 Main Harness B (MB991911)
Used when connecting V.C.I. with vehicles that have a
16-pin + 12-pin or 16-pin + 13-pin diagnosis connector.
For models equipped with only 12-pin (or 12-pin + 12-pin)
diagnosis connector, connect the M.U.T.-II adapter harness
(MB991498) to the end of this harness in the same as
M.U.T.-II, and power is supplied from the cigarette lighter
socket.
For more Car Diagnostic Scanner,please visit our shop
Contact Us:
Skype: obd2works
Email: obd2works@gmail.com
MSN: obd2works@hotmail.com